Furman M-8S - 15A Standard Power Conditioner with Sequencer

Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.

• Power Sequencing
  • Prevents excessive inrush currents.
  • Six sequenced rear panel outlets (in three groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
  • Momentary and maintained sequencing via rear panel terminal block or front panel switch (momentary only).
• Noise Filtration
  • Noise filtering to reduce radio frequency and electromagnetic interference.
• Surge Protection
  • Ensures equipment stays safe.
• 9 Total Outlets
  • Eight rear panel outlets and one front panel convenience panel outlet.
• 15 Amp Rating
  • 15 amp rating, with circuit breaker.
• “Protection OK” Indicator
  • Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status.
• Wall Wart Spacing
  • Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.
• All settings and configurations available on rear panel.

Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system where power sequencing is desired.

Install an M-8s in to the top slot of your rack, and the six delayed outlets in the rear panel will power up sequentially and protect all your equipment up to a 15-amp load.

Includes 3 delayed outlet banks – each with 2 outlets – plus 2 unswitched outlets.

Specs

• Maximum AC Current Rating - 15 Amps, 120 VAC (Thermal breaker)
• AC Cord - 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
• Convenience Outlet (Front Panel) - 1 Un-switched NEMA 15-5R
• Rear Panel Outlets - 2 Un-switched NEMA 5-15R (1 duplex)
  6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
• AC Surge Protection - Merit Class (sacrificial)
• Spike Protection Mode - Line to neutral, zero ground leakage
• Max Continuous Operating Voltage - 130V RMS
• Max Clamp Voltage - 500 Volts Peak
• Peak Impulse Current - 12,000 Amps
• Energy Rating (2 X 820µS) - 225 Joules
• AC Filtering - Pi LCR Filter
• Noise Attenuation - >26dB, 100 Khz to 1 MHz
• Operating Temperature Range - 5C (40F) to 40C (105F) degrees
• Humidity Range - <90% rH (Relative Humidity)
• Rocker Switch - Front panel, Sequence (ON, OFF)
• Thermal Circuit Breaker - Front panel, push to reset
• Front panel indicators - Delay 1, Delay 2, Delay 3, Power, Protection OK
• Control/Status/Triggering (Rear Panel) - Rear Panel DIP Switches: 12V Mode On/Off,
  GND Mode On, Momentary/Maintained
• Potentiometer - Rear panel, time calibration fine tune delay adjust
• Remote Terminal - +5-30VDC In, 12VDC (12mA) Out
• Remote Terminal - Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)
• Size - 1.75” X 19.00” X 6.5” (HWD) – ANSI 1RU
• Mass - 5.3 lbs.
• Power Consumption (No Load) - 5 Watts
• Safety Agency - C/CSA/US